450 USB CDC (Serial) Device

450 : USB CDC (Serial) Device

Design render

How it works

A USB CDC to UART bridge, based on tinyfpga_bx_usbserial.

How to test

  1. Connect usb_p and usb_n pins to D+ / D- USB pins either through 68 ohm resistors or directly (the resistors are recommended, but not mandatory).
  2. Connect a 1.5k ohm resistor between dp_pu_o and usb_p (D+).
  3. Connect the RX and TX pins to a UART device or to a logic analyzer.
  4. Set the clock frequency to 48 MHz.

The device should appear as a serial port on your computer, with vendor_id=1209 and product_id=5454 (https://pid.codes/1209/5454/). The baud rate for the UART interface is hardcoded at 115200.

Demo mode

Set ui_in[0] high to enable demo mode. In this mode, the device sends "Tiny Tapeout!" over USB once per second. UART RX input is ignored while demo mode is active.

External Hardware

USB breakout board, 1.5k ohm resistor

IO

#InputOutputBidirectional
0demo_modeusb_p
1usb_n
2dp_pu_o
3RX
4TX
5
6
7configured

Chip location

Controller Mux Mux Mux Mux Mux Analog Mux Analog Mux Mux Mux Mux Analog Mux Mux Mux Analog Mux Mux Mux Mux tt_um_chip_rom (Chip ROM) tt_um_factory_test (Tiny Tapeout Factory Test) tt_um_tnt_gf_555 (tnt's recreation of a 555 on GF180mcu) tt_um_mcml_vco (MCML VCO) tt_um_tnt_gf_vco (Quadrature VCO) tt_um_oscillating_bones (Oscillating Bones) tt_um_MichaelBell_tinyQV (TinyQV Risc-V SoC) tt_um_essen (256x8 SRAM) tt_um_analog_factory_test (TT GF180mcuD Analog Factory Test) tt_um_cw_testbuffer (TT GF180mcuD Testbuffer) tt_um_fabulous_gf_0p3 (Tiny FABulous FPGA) tt_um_fabulous_gf_0p3_3v3 (Tiny FABulous FPGA (3.3V version)) tt_um_htfab_momcap (MoM capacitor) tt_um_gf_r2r_dac (GF R2R DAC) tt_um_AbAdA_2048 (Abad2048) tt_um_mattvenn_signal_generator (Simple Signal Generator) tt_um_74hct00 (74HCT00 Quad 2-Input NAND (3.3 V)) tt_um_algofoogle_gf_analog (algofoogle analog stuff) tt_um_LPCAS_TTGF0P3_TP1 (3.3V Folded Cascode OTA ) tt_um_kianV_rv32ima_uLinux_SoC (KianV uLinux SoC) tt_um_kiterai_current_dac (Analog 4 bit Current DAC) tt_um_urish_simon (Simon Says memory game) tt_um_waferspace_vga_screensaver (Wafer.space Logo VGA Screensaver) tt_um_urish_usb_cdc (USB CDC (Serial) Device) tt_um_a1k0n_nyancat (VGA Nyan Cat) tt_um_rahulbhagwat_gf180_bandgap_reference (GF BGR) tt_um_odgrip_polywave (PolyWave) tt_um_2048_vga_game (2048 sliding tile puzzle game (VGA)) tt_um_combined (Philippine flag waving) tt_um_gojimmypi_ttgfa_UART_FSM_TRNG_Lab (Hardware Entropy Explorer: UART/SPI TRNG and PUF) tt_um_gojimmypi_ttgfa_UART_FSM_TRNG_Lab_analog (Hardware Entropy Explorer: UART/SPI TRNG and PUF (Analog)) tt_um_coldbrew (Until heat death do us part) Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available Available